How to Do Auto Level Calibration?

How to Do Auto Level Calibration?

Those dealing with test equipments know well about calibration. It is the checking or adjusting an equipment by comparing it with a standard- for getting accurate measurements. Auto level is one of the many survey instruments that needs calibration. Here is a step by step instruction guide on how to calibrate this survey equipment. If you want to do it yourself, this guide will help you in your auto level calibration.

* Open the cover of the instrument by unscrewing the top, bottom, left and right screws. If you only want to do collimation (adjust accurately the line of sight), then you have to adjust only top and bottom screw.
* After opening the cover, set the auto level in the center of 2 staff (having approx length of 60m) and get the reading of Backsight (BS)- point A and foresight (FS)- point B. Ensure that the instrument is well leveled before reading. This difference of BS and FS you get by doing this is without collimation and the reading should be taken as benchmark for adjustment.
* Now shift the equipment to point D which is L/10 (L is the length of point A to point B).
* Read the nearest staff and write down the value. Add this value with the difference of BS and FS which you got in the step 2.
* Now use screw to lose and tighten bottom and up screw. Adjust slowly - if you lose top screw then tighten bottom screw and read the staff to get the "Actual value". This way your calibration is complete and you get the perfect value or a value that has a difference of 1 mm.
* After your auto level calibration is done, get back the alignment. Go back to center of point A and B. Check the reading again. Now you should get the perfect reading.

Once you have calibrated the instrument, you will be using it in the field. For properly using as well as checking it, read How to Use an Auto Level? It will also give you some tips on caring and maintenance of auto levels.

Kids Line Ladybug Bedding clip on aerobars for road bikes dog wicker basket